CURVE CLUMP/REPEL
Clumps or repels selected curves with ramp fall off control
|
|
- Source:
- Center - Uses the center of all selected curves as snapping target
- Last Curve - Uses the last curve selected as snapping target
- Reverse Direction:
- Turn this on to reverse the snapping falloff of selected curve(s).
- Limit Falloff To Shortest:
- If disabled, the falloff slider does NOT have an affect. Curve snapping/repelling will respect only to the Strength Ramp instead.
- If enabled, will limit the maximum fall off distance to the shortest curve selected. Curve snapping/repelling will respect to both Falloff and Strength Ramp instead.
- Falloff:
- All operation will require this to be slid first in order to determine the snapping radius.
- Multiplier:
- Strength of to apply to clump/repel operation. Above 0 = clump, below 0 = repel